You are deploying a new network lo support your Al workloads on devices that support at least 400 Gbps Ethernet. There is no requirement for any Layer 2 VLANs in this network. Which network architecture would satisfy this requirement?

1. A. an IP fabric using PIM-SM to signal VXLAN overlay
2. B. an IP fabric using the EVPN-MPLS architecture
3. C. an IP fabric with an EVPN-VXLAN architecture
4. D. an IP fabric using EBGP

Correct Answer: D

Exhibit.

You have implemented an EVPN-VXLAN data center. Device served must be able to communicate with device server2.
Referring to the exhibit, which two statements are correct? (Choose two.)

1. A. An IRB interface must be configured on spine1and spine2.
2. B. Traffic from server1 to server2 will transit a VXLAN tunnel to spinel or spine2. then a VXLAN tunnel from spinel or spine2 to Ieaf2.
3. C. An IRB Interface must be configured on leaf1 and Ieaf2.
4. D. Traffic from server! to server2 will transit the VXLAN tunnel between leaf1 and Ieaf2.

Correct Answer: AB

Which two statements are true about EVPN routes for Data Center Interconnect? (Choose two.)

1. A. Type 5 EVPN routes require a VXLAN tunnel to the protocol next hop.
2. B. Type 2 EVPN routes do not require a VXLAN tunnel to the protocol next hop.
3. C. Type 2 EVPN routes require a VXLAN tunnel to the protocol next hop.
4. D. Type 5 EVPN routes do not require a VXLAN tunnel to the protocol next hop.

Correct Answer: BD

A local VTEP has two ECMP paths to a remote VTEP
Which two statements are correct when load balancing is enabled in this scenario? (Choose two.)

1. A. The inner packet fields are not used in the hash for load balancing.
2. B. The destination port in the UDP header is used to load balance VXLAN traffic.
3. C. The source port in the UDP header is used to load balance VXLAN traffic.
4. D. The inner packet fields are used in the hash for load balancing.

Correct Answer: CD

You are asked to set up an IP fabric that supports Al or ML workloads. You have chosen to use lossless Ethernet in this scenario, which statement is correct about congestion management?

1. A. The switch experiencing the congestion notifies the source device.
2. B. Only the source and destination devices need ECN enabled.
3. C. ECN marks packets based on WRED settings.
4. D. ECN is negotiated only among the switches that make up the IP fabric for each queue.

Correct Answer: C