What is the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration?

1. A. DHCP
2. B. Static
3. C. Broadcast
4. D. Multicast

Correct Answer: B

Which two phases are part of the process to plan a wireless design project? (Choose two.)

1. A. Project information phase
2. B. Hardware selection phase
3. C. Site survey phase
4. D. Installation phase

Correct Answer: AC

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

1. A. Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
2. B. Areas with the signal strength weaker than -68 dB are cut out of the map
3. C. Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor
4. D. Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.

Correct Answer: D

Refer to the exhibits.
Exhibit A

Exhibit B

The exhibits show the diagnose debug log of a station connection taken on the controller CLI. Which security mode is used by the wireless connection?

1. A. WPA2 Enterprise
2. B. WPA3 Enterprise
3. C. WPA2 Personal and radius MAC filtering
4. D. Open, with radius MAC filtering

Correct Answer: C

As standard best practice, which configuration should be performed before configuring FortiAPs using a FortiGate wireless controller?

1. A. Create wireless LAN specific policies
2. B. Preauthorize APs
3. C. Create a custom AP profile
4. D. Set the wireless controller country setting

Correct Answer: D